Posts Tagged With: Lombard hauler

Maine’s first electric sawmill

Everything changes with time, and the lumber industry of Maine has not been an exception to the rule. Today, we’re used to these machines that can drive into the woods, cut and de-limb a tree, de-bark it and load it into a pulp truck in less time than most folks take to smoke a short cigarette. It wasn’t always that way, but as time progressed, Mainers kept up with technology, adopting those methods and machines that fir the bill, and adapting others that didn’t exactly fit the bill, but could with a little tweaking. A 1921 issue of Popular Mechanics had a few articles that looked at this very same knack that die-hard Mainers have for adopting and adapting, as the need fits.

In the first article, we read that Maine seems to have been a pioneer in using electricity to run their backwoods sawmills, and the report says that we had the first ever such mill to replace steam and water powered mills for the task of sawing logs into useable lumber.

A second article from that same magazine shows that one of the backcountry lumber operations adapted a modern gas or diesel powered version of the Lombard Hauler to tow a converted box car to haul cargo, the mail and people back and forth from the deep woods of Maine.

The third article isn’t about technology, but it is about someone adapting materials at hand to fill a need. A couple of deep woods camp owners, female at that, utilized a log to make a unique table for their camp. Cutting the log in half and using the smaller diameter upper parts of the tree for legs, they hand milled the table top with a broadax, planed the flats until they were smooth and varnished the table until it had a glossy finish. I guess we know why they call it a broad ax now. (Just kidding, no offense meant!:0)

Categories: articles, history, stories, Uncategorized | Tags: , , , , , , | Leave a comment

The Lombard Log hauler

A Unique Waterville Industry

Manufacturing a Steam Log Hauler that, meets with popular favor among the lumbermen, the business of A. O. Lombard, Waterville has grown to large proportions and volume since he became established in 1903.

When the business was founded the facilities were small, to-day the firm occupy about 20,000 square feet of floor space, with modern offices, fire proof boiler house, spacious machine shops etc. In 1910 the firm erected a new and modern brick building two stores high 110 x 38 feet which is fire proof throughout.

The lower story of the new addition is used for assembling the Log Haulers, the upper story being devoted to the construction of gasoline engines for traction purposes. The Lombard Steam Log Haulers have an unsurpassed reputation in the United States and Canada and are known to be first-class and soundly serviceable, each hauler developing 100 horse power. Every outfit made at this plant is designed with the greatest care, constructed skillfully and painstakingly by experienced workmen and the highest grade and most durable material only is used. Employment is given to about 22 hands, all of whom earn good wages.

Mr. A. O. Lombard, the inventor, who still remains the head of the business, was born in Springfield, Maine, and has been a resident of Waterville for 16 years. His progressiveness and sagacity in the conduct of his present enterprise have given him a sound and desirable standing in the commercial world.

So says the Board of Trade Journal in a May 1910 edition of that then popular business magazine. Lombard, an inventor from Waterville Maine gave the logging industry a swift kick in the pants, providing a new way to maximize productivity for the timber harvest here in Maine, and elsewhere as well. There were other versions of this steam-powered tractor, such as the Canadian variety produced by the Jenckes Machine Company of Sherbrooke, Quebec and the Western variety made by the Phoenix Company in Eau Claire Wisconsin. The Lombard version was considered the best in the industry, however.

The Lombard was capable of pulling many more sleds than a team of oxen or mules were, capable of pretty much creating their own roadways, and were much better in the snow than other means of hauling logs were. This made the tractor a favorite choice as it was much more economical, and saved much labor, thereby reducing harvesting costs even further. Nevertheless, it did have its drawbacks. Downhill runs were dangerous as there was no way to brake the hauler, and sleds loaded down with logs were prone to jackknifing and overrunning the tractor. For this reason tracks were made with steep sides to run the “train” in to prevent this from happening. “Snub lines” and Barienger Brakes were also used at times on particularly steep grades.

The following piece is from the Horseless Age magazine, vol10, issue 22, in which Lombard writes a letter to the editor describing the haulers:

A Steam Logging Outfit

Waterville, Me., November 21. Editor Horseless Age:

We have just completed one of our steam log haulers, run it .out of the shop and taken a picture of it, which you will find enclosed. You will notice that the machine now has wheels under the forward part: we use wheels in the summer and a sled in the winter; the rest of the machine remains the same both summer and winter. You will notice in looking at the photo that we have an endless lag bed which makes the rear runner carry practically the whole weight of the machine of about 15 tons, with the exception of about 1 ton that bears on the forward sled. The runner is driven by a pair of engines and takes its steam at five-eighths stroke, so it can never get on dead centre. The runner, or endless lag bed, which you can see in the picture, is made of steel castings jointed together in such a way as to run over the sprocket wheels with toe cocks cast on them, the same as on a horse, so when they come in contact with the snow or ground there can be no slipping, even if it strikes the glare ice. This runner is driven through its rear sprocket wheel, which is constructed in such a way that the runner can tilt at any position that the road may require. The entire weight of the machine sets on a 5-inch axle running through the runner and hung loose at the ends so that the runner always tilts easily over rough going, rocks or anything that it may come in contact with, with a remarkable easy and quiet motion, which it is impossible to get from a round wheel. The opposite side of the machine is a duplicate of the side you see in the picture.

The machine is driven by a 100 horse power equipment. The boiler is a regular locomotive boiler fitted up with the necessary injectors, water tank and suction hose for taking water from springs or streams along the road: also with a cabin and wood box in the rear, as we always use wood, for the reason that using wood is far cheaper in the lumber woods than to use coal. The machine is reversible, the same as a locomotive, and will run one way as well as the other. It has a force draught, caused by the exhaust, the same as a locomotive: it also has a governor on the steam pipe just before it branches to each engine, which governor controls the speed of the machine and is belted to the main shaft.

This governor is set to give the machine a speed of 5 miles per hour, and presents the advantage that the engineer may pull the throttle wide open and the machine will take care of its own speed in plunging in and out of sharp pitches and cradle knolls, and gets the necessary steam ior up hill. This machine, without any load hitched to it, is capable of climbing any grade that a man can climb up afoot. Our experimental machine, which we had in the woods last winter, could easily carry 20.000 feet spruce lumber per load over a logging road of 7 miles and make two turns per day. The reason why we put on two sets of double engines, making four cylinders in all, is to get rid of the compensating gear: in making turns in the road one pair of engines runs a little faster, which makes it the best possible compensating arrangement. To steer this machine we put one horse in the shafts of the sled that belongs under the front end, tie up the reins and let him go. We never ask him to start or stop.

The Lawrence. Newhall & Page Company, of Shawmut. Me., have bought the experimental machine that we had in the woods for them last winter; also the two new machines now under construction, which are practically all done, and of which enclosed is a photo. They intend to move on a road of 7 miles their entire output of lumber, making 7.000.000 feet. According to our experiment last winter we can haul as much lumber for about $8 or $10 expense as they can for $too expense with horses, to say nothing about the larger depreciation in horses compared with this machine. We hitched up four of their lumber sleds, one behind the other, and put S.ooo feet on each sled. The front sled has a coupling on the end of the pole, the machine is backed up and a pin dropped, the same as on steam railroads. This machine is especially useful in snow to break out its own roads or to haul snow plows after big storms, etc. A patent was granted on it May 21. 1901.

A. O. Lombard

When all is said and done, in spite of the gas and diesel motors rapid development, Lombard’s steam tractor did indeed provide a valuable piece of equipment to the logging industry. It proved the value of machine of sheer animal power in the field, and spelled an end to the era of twitching logs with ox teams and horses or mules. The Lombard Hauler gave way to gas powered skidders and tractors as the even greater power they provided decreased the costs of harvesting even more.

Lombard also developed an electric log hauler which he named the “Forest Echo,” and operated it in the area of Alder Stream. This also was a successful invention, though nat as popular as the steam and later gas powered haulers as a system of electric wires was required to operate the machine. The electric hauler had an engine of 25 horsepower, weighed fourteen tons, and on a test run pulled a load seven miles that scaled 17,280 board feet of logs.

Maine has a long line of inventors to her name, and some, such as A.O. Lombard achieved renowned success, and a success that we true Mainers can be proud of.

The Lombard Hauler gas powered version

Another view of the Lombard Hauler

Categories: antiques, history, Maine, Uncategorized | Tags: , , , , , , | Leave a comment

Logging with Tractors in the Maine Woods

Casting Call for New Collecting Television Show From Worthpoint
Is collecting a part of your daily life? Are parts of your collection in every room of your house? Do you have unique and special objects that you are extremely proud of? Finally, do you want to show off your collection on television? The producers of “My Collection Obsession,” which will air on a national cable network, are currently looking for serious and dedicated collectors of all kinds who could appear on the show. Find out if your collection is truly obsessive enough to make the cut. Read”Casting Call for New Collecting Television Show”

PHOTO: Museum L-A site work begins

“It’s starting!” exclaimed an excited Rachel Desgrosseilliers, Museum L-A’s executive director, as she watched workers at the future site of the museum Thursday in Lewiston. Benjamin Construction’s Richard Lee, left, and Ed Benjamin, in the skid steer, were demolishing damaged sections of t…

Textile industry heritage celebrated
SOUTH BERWICK, Maine — A special fund-raising event that gives a nod to the thriving textile industry of the past will benefit the Old Berwick Historical Society this weekend. The Lighting Up Ball and second annual silent auction will be…

Presentation to feature Maine Indians
LISBON FALLS — The Lisbon Historical Society will host guest speaker and author, Nicholas Smith of Brunswick, at 7 pm Wednesday, Nov. 9, at the MTM Center. Smith will give a presentation on his recently published book, “Three Hundred years in Thirty,”…

~~~

Logging with Tractors in the Maine Woods

Popular Science Monthly, 1916

LOGGING has remained for generations the most primitive of all modern operations. The logging railroad is a comparatively recent development, but even that falls far short’of being an active agent in reducing the vast waste necessitated by the fact that only such timbers can be moved out as will pay for expensive transportation. In the tropics a mahogany log worth hundreds of dollars in New York is valued at only a few demonetized dollars as it stands in its forest, and almost priceless hardwoods are left to rot or burned up in the clearing of ground simply because they cannot be “squared” to the formal size, about one foot on each side.

To a lesser degree the same problem faces the timber cutter in the forests of our own country. The long hauls through the woods to streams or roads, even to the roughest sort of logging roads, is discouragingly expensive, and from there to the railroad or mill entails another long haul with primitive means, either oxen or horses.

Modern power appliances are, however, slowly coming into use as they prove their worth. In certain sections of the Maine woods, where logging is the winter occupation of fanners from nearby sections, tractors are now in use. The drive on these engines is by caterpillar wheels, broad enough to keep from sinking into the snow, and the forward part of the tractor is mounted on sleigh runners, which are turned by hand to guide the tractor and its train of logging sleds.

The tractor is crude in a way, but it can reach sections of forest country to which even the ordinary logging railroad, with its clumsy engine, cannot readily penetrate.

In the tractor shown here, the runners at the front make steering easy and accurate. The unwieldy front wheels of the ordinary tractor would hardly serve in the forest.

Categories: articles, breaking news, events, headlines, historic preservation, history, museum news, stories, Uncategorized | Tags: , , , , , , | 2 Comments

Create a free website or blog at WordPress.com.

%d bloggers like this: